3800Pro Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
361 Posts
Discussion Starter #1
Hey,
I need a Vacuum harness from an L67, complete would be best.
Lemme know what you have, and for how much.
Thanks,
-Jared
 

·
Registered
Joined
·
230 Posts
buy some rubber vacum hose in two different sizes and make your own trust me doen this on 4 different 3800's and works fine and isnt that cheap plastic **** gm uses....
 

·
Registered
Joined
·
28 Posts
and if you do buy a harness from someone make sure its the right year my 97 vac lines were completely different from a 2000
 

·
Registered
Joined
·
361 Posts
Discussion Starter #6
buy some rubber vacum hose in two different sizes and make your own trust me doen this on 4 different 3800's and works fine and isnt that cheap plastic **** gm uses....
and if you do buy a harness from someone make sure its the right year my 97 vac lines were completely different from a 2000
Not bad ideas. Thanks, guys.
Would I need to clamp them, or will the barbs hold everything?
 

·
Registered
Joined
·
230 Posts
i zip tie every slide on connection but thats me its probablyl not required...
 

·
Registered
Joined
·
28 Posts
i dont even think we zip tied mine when we did it jay(heep)i think we just connected them and left it
 

·
Registered
Joined
·
230 Posts
no zip ties i think only a couple of mine are but its good insurance if you really want to do it..
 

·
Registered
Joined
·
361 Posts
Discussion Starter #11
for how cheap they are, I think they're damn good insurance/piece of mind. :)
 

·
Registered
Joined
·
28 Posts
zip ties? cheap cheap like 5 bucks for 200
 
1 - 13 of 13 Posts
Top