3800Pro Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
Will the DTC table on Autotap show missfire codes if there is ever a missfire? or do u have to add the missfire cylinders to the regular table to track it?

thanks
Jon G
 

·
Registered
Joined
·
565 Posts
It will only show if you have enough misfires to set the DTC/SES light. If you want to monitor them at all times, you will have to add the parameters.
 

·
Registered
Joined
·
57 Posts
Discussion Starter · #3 ·
ok thanks. are there certain cylinders that would missfire more then others? or should i add all of them?

thanks
Jon
 

·
Registered
Joined
·
565 Posts
If you want to monitor them, I would monitor all of them. There isn't necessarily 1 cylinder that misfires more than others. You never know which plug/wire will go bad first.
 

·
Registered
Joined
·
1,224 Posts
Are you currently getting random misfires? Are you throwing any misfire codes? P0300?
 

·
Registered
Joined
·
1,224 Posts
So you just want to scan for them, even though you are not getting any?
 

·
Registered
Joined
·
57 Posts
Discussion Starter · #8 ·
basically i want to know just in case

thanks
jon
 

·
Registered
Joined
·
1,224 Posts
No prob i was just currious. Now I dont know this for sure but if you add too many things to scan, that it can slow the autotap sown and you wount get as many scans per second. i dont know for sure, just something i heard.
 
1 - 9 of 9 Posts
Top