3800Pro Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So got a 1994 with original 3800 L27 engine, was rebuilding it from the block up then just said ef it might as well do it all so I’m pulling it all out. Now as far as taking the front apart I know all that, just not sure what would be easiest route to go for me, it’s mainly going to be just me working on it, already have a hoist set up and most of the top wires and hoses disconnected, haven’t got to the fluid yet but is there anything else I need to watch for on these that needs taken apart before I pull it? And would it be easier to pull motor and tranny out together then decouple them or is it pretty easy to disconnect in the bay? And if taking out together what all needs disconnect mechanically? Not planning on doing anything other than fluid and filter for transmission. Thanks for any input and advice all appreciated
 
1 - 1 of 1 Posts
Top