PRJ Fuel Rails Vacuum Lines
1 - 2 of 2 Posts
Howdy,
Without writing a long drawn out post, I will say that you need to eliminate your vacuum tee for the stock regulator by using a 1 inch section of 1/8" vacuum line.
Next, locate a vacuum tee that is identical to the one that goes into lower intake below supercahrger. Replace tee on map sensor with new tee. This allows you to add a piece of rigid 1/8" vacuum tubing will go to your new regulator. It will also be necessary to locate a tee that matches your new section of 1/8" tubing and the fitting on your new regulator.
Hope this helps!!!!
BIG JEFF
Without writing a long drawn out post, I will say that you need to eliminate your vacuum tee for the stock regulator by using a 1 inch section of 1/8" vacuum line.
Next, locate a vacuum tee that is identical to the one that goes into lower intake below supercahrger. Replace tee on map sensor with new tee. This allows you to add a piece of rigid 1/8" vacuum tubing will go to your new regulator. It will also be necessary to locate a tee that matches your new section of 1/8" tubing and the fitting on your new regulator.
Hope this helps!!!!
BIG JEFF
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Join the discussion
3800Pro Forums
A forum community dedicated to all General Motors makes and models owners and enthusiasts running the 3800 series engine. Come join the discussion about performance, modifications, classifieds, troubleshooting, builds, tunes, superchargers, maintenance, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!