3800Pro Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter · #1 ·
Mods;

Stg. 3 heads/cam (9.0:1comp)
Stg.4 blower (3.0" pulley)...I know...I can use a way smaller pulley :rolleyes:
N.S. TB
Stock injectors :eek:
DHP PCM (AFC 2.0/Adj. timing)
ZZP Stg. 2 I/C
SLP headers (3" exh.)
Oversized Rad. (just thought I'd add that)
FWI

I use Autolite 103s....w/ a gap of .050. Should it be closed more or what??
Oh, I run 91 & 93 on the street and 110 at the track.

Thank You!
 

·
Banned
Joined
·
189 Posts
Shawn,


A gap of .050" is o.k. for your setup. We have run as low as .045" with smaller pulleys in race trim. This seems to cause a little bit of rough idle on the street though.

BIG JEFF
 

·
Registered
Joined
·
565 Posts
seen96 said:
Mods;

Stg.4 blower (3.0" pulley)...I know...I can use a way smaller pulley :rolleyes:
Stock injectors :eek:
I wouldn't go below a 3" pulley until you get some bigger injectors. ;)
 

·
Registered
Joined
·
108 Posts
Discussion Starter · #4 ·
Exactly......I'm waiting till I get some money worked up again, and I'm gonna get 50lb.'ers and then the 2.6" pulley.
As far as the gap, I was curious be cause at high speed runs at WOT it starts to miss. Its NOT KR.
 

·
Registered
Joined
·
565 Posts
Well, 0.050" should be okay for your mods, but since you are missing at WOT, maybe it's not. Are you sure the plugs are good? If so, you could try decreasing the gap a little and see if the misfires go away.
 
1 - 5 of 5 Posts
Top