3800Pro Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I have a 1988 Fiero GT with a L32 and the oil pressure gauge is pegged at full sweep with KOEO. I checked the oil pressure sensor and there is nothing connected to it and no wiring anywhere to be seen. How can I get this hooked up and working?
 

·
Super Moderator
Joined
·
885 Posts
Fiero.nl has a whole 3800 swap section on their forum. Based on how many little issues you're having, I'd use a combination of here and there to get relevant commentary. I pasted a wiring diagram from there below, not sure if it has what you need, but it's a start. You're probably going to spend a little while longer learning your car due to buying someone else's project, but you can certainly get it dialed with effort.

Product Rectangle Slope Font Schematic
 
1 - 3 of 3 Posts
Top