3800Pro Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
122 Posts
Discussion Starter · #1 ·
I have a 99 GTP with almost 85 k on the engine.
3.4 MPS, 3'' rtd, thrasher cai
2 step colder plugs, 180 stat
Intense PCM, SLP loudmouth
[email protected]
Those are the mods i have done so far. I was looking into getting the 1:9 full roller rockers but need some help on my decision. Also if anything, what risk am i running maybe on the bottom end if I install these.
 

·
Banned
Joined
·
189 Posts
Howdy,


If you are going to do a camshaft or rockers, valve springs and perhaps titanium retainers are something to
consider to prevent valve float, specifically on a high mileage engine.



BIG JEFF
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top