3800Pro Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
I have arp head studs, ARP recommends 70 lb ft for the final torque but also recommend manufacturer torque sequence. What is the manufacturer torque sequence.
 

·
Registered
Joined
·
134 Posts
Also might suggest that you make sure to use the correct GM sealent on the head studs, because they go into the water jackets. You can just use Tefflon Paste from any hardwear store IMO.

Pre torque the studds once the stud holes have been cleaned with a tap to make sure everything is clean. Pre torque to 10ft. lbs. Now you are for sure that the studs ahve bottomed out in the block.

~Farnsworth~
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top