3800Pro Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
93 Posts
Discussion Starter · #1 · (Edited)
just a general question... I don't have a micrometer and i am wondering what that diameter is?

Also, the inter diameter of a pulley must be like 1-2 thousandths smaller for the pressfit, anyone care to elaborate on this for me???
 

·
Registered
Joined
·
1,305 Posts
I am pretty sure you need a FEW measurements with a Micrometer to figure out the taper. AS IIRC the shaft is tapered.
 

·
Registered
Joined
·
93 Posts
Discussion Starter · #3 ·
yes i know... Actually, have a mircometer now, i am taking measurements later tomorrow...

I know the pressonpulley diameter is 1-2K smaller than the tappered shaft to account for shrinkage and growth.
 
1 - 3 of 3 Posts
Top