3800Pro Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Finally finished the aluminum intake. It's Diablo Red Kandy on the bare aluminum, topped with Nukezilla Chameleon Pearl. Then it's dipped in a custom carbon skull pattern that was resized to fit the intake better. The skulls were orginal fist size.
10945
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
Shipping wasn't bad on it, gimme a shout if you decide you want to do it. I media blast it , 48 hour solvent soak, prime, paint and clear with a 2000° resistant paint. Dip for most stuff starts at $100 and goes from there. I've done trim, shotguns, lights, even my avatar is a headlight projector lens I dipped. Not much I can't dip, I also build custom headlights and tail lights. I'm on Facebook and YouTube if your interested.
11118
 

·
Registered
Joined
·
4 Posts
Definitely will give you a buzz for sure when I'm ready. Everything looks good. I sent you a direct message on here also. Have a look at your Inbox when you have time.
 
1 - 6 of 6 Posts
Top