Search Results for ‘l67 swap’

Im building an L67 3800 over the next few years until my LN3 3800 in my Reatta craps out on me. I have looked and it seems everyone just says its a lot of money and that power is unreasonable on a budget. but I'm not, I have plenty of time until my current engine blows. I was thinking a 4t65e-HD...

Hi all, I have a 2002 Camaro with an l67 in it. I just changed the plugs from AC Delco 41-101 Iridium to Autolite 605 Copper which I have heard are suitable for boosted applications. After swapping the plugs out, the car now cuts out when nearing boost while driving. This had never happened...

I am tuning my friends L67 swapped 2002 f-body and we have run in to an issue where the car idles very rough and will surge to over 2300 rpm before we shut the engine off. We hooked up a vacuum gauge to the intake tube and it showed basically no vacuum. I think the issue could be the throttle...

Hey to all, looking for guidance on building a drivers side cv axle. I swapped a Series II L67 w/4t65e-hd into 90's "E" platform and would like to reuse the original outer cv ends native to the vehicle. I have successfully built a passenger cv so far using a mix match between donor and...

Ok, I'm sure this is something that has been asked a million times on here and it's gotten old, I promise it's not exact, but here we go. I did an L67 swap into an 03 Impala out of an 02 GTP, I know common sense it to just swap computers, I did and failed, with the GTP ECM in the Impala I get...