Coolant Level Error

granniesngtmr98 · #1 (**permalink**) 03-16-2008, 07:45 PM

I just successfully dug down into the LIM to change the LIM/UIM gaskets as a last resort to fix the lean code...worked like a charm. (not to mention the 2 spots i found the UIM gasket had blown out!)

I had a flashing coolant level sensor...figured i should change it when the juice was drained...

The car is now full of coolant, and i have driven it then refilled...blah blah

The light...it's on strong now, with the new sensor in place.

I must have started the car 7 times since it's been in there and i also tried just unplugging the harness and replugging it, nothing has seemed to work.

The car runs at normal temp...

Any ideas??

BillBoost37 · #2 (**permalink**) 03-17-2008, 06:33 AM

Check for continuity or grounding of the wiring to the pcm. Could be a pinched wire. Also check that the sensor works properly with a multimeter.

granniesngtmr98 · #3 (**permalink**) 03-17-2008, 08:34 AM

Good Deal...Thanks!

SUPER_GTP · #4 (**permalink**) 03-17-2008, 08:46 AM

Unplug the sensor...That's what I did...Everyone cool is doing it.

Actually it turned out to be a bad connection for me. Good luck.