- Gah! Impossible oil leak!
- Series 1 SC injectors work for L36?
- 03 impala acting weird!
- Just got a 04 Impala SS...need a little advice
- Running problem?
- Help me build my engine!
- Please don't be what I think it is...
- Some Help with an '88 3800 Damaged Piston
- series I performance
- somebody help!!!!!!!!
- MSD ignition?
- Another new short block in the N/A
- 1988 3800 Head gasket?
- harmonic balancer pulley
- new trannie?
- Looking to mod my 3800
- 3800 engine
- High KR
- Good Start Mods to 3800? - stock
- Clearance Problem
- a good challenge
- Hello and My Car Died! (Story of a Lifetime)
- what do you guys think??
- Car wont turn over
- Need Help, Gas Smell
- 2000 Impala 9c1
- o2 Issues/Bumpy Idle/SES Light/ Im out of ideas...
- 300 Hp L36?
- stock motor cars...
- L26 UIM onto L36
- reflash?
- what size injector for E85?
- L27 Mods?
- problem after cam install
- The cam's going in!!
- L36 Mods?
- gt problem maybe?
- slooow
- series 1 na compared to series one l67
- thinking about
- whats the fastest car? with intense cam
- gt mods
- Help Excessive Crankcase Vacuum
- L36 heads
- Stage 3 na car
- S1 NA cam etc..Won't idle
- O2 levels/Rough Idle
- my new set up need some opinions
- 200 WHP, what's the best route?
- Where should the PCM be placed at
- gt mods
- a few q's for the pro's
- will i be ok?
- high reving
- What would it take?
- Cam Install Questions
- safest way to get 10:1 compression?
- High Idle Issue.......???
- sound clip
- what compression are you running?
- More Power
- Torque Specs on Intake
- A fluke?
- Up n running
- intense stage 1 cam kit
- L36 MAF Question?
- Car not starting well...
- EVAP switch identity
- non plastic intake?
- L36 MAF Range
- new PB for my L36
- Best mods for improved Economy?
- Is my Fuel Pump is DEAD ????
- Speed Limiter
- L26 head
- excessive crankcase vaccum
- Hvii Gen 3
- Backfire,stalling etc....
- power
- A couple of question about the L36 engines
- New throttlebody setup
- who has stage 3 heads
- Suggestions!!??
- 4.3 v6 crankshaft?
- Engine bogging when hot
- i got problems after rebuild
- i got problems after rebuild
- sound clip of my LN3
- need help plugging coolant holes in the LIM
- Kr ?
- Please Help!!!!!!!!
- HELP!! Engine trouble....
- Vacuum Question
- New N/A setup up and running
- whats next ?
- Belt Tensioner Failure
- Spark Plugs
- HV insert?
- 07 gp
- Intake Gasket Change
- L 36 LIM porting
- where to buy wires?
- 95 LeSabre New motor question.
- new-be? honeycomb filter in front of TB?
- L26 UIM and HV3
- Top end knock, Bad oil pump?
- Sputtering/cutting off Series I
- Help?!?
- No throttle response
- Weird electrical problem??
- Hv3 Insert
- Exhaust question
- Who has N/A plans in 07?
- top end
- Best Mods???
- dorman intake
- want to put the button n?
- 1998 horsepower vs 1999
- T-stat ?
- Help cant break 15
- Power Log question
- want to know a good set up.
- did not get much responce from the turbo space so i moved it here
- Will this work?
- The 442 will be 7.6L (build begins)
- Has anyone boosted a N/A 3800?
- L36 blueprint specs
- Where to start with L36?
- 300 HP ASPIRATED ECOTEC (series 2) ?
- remove rear transmission on 98 grand prix
- 11.5:1 compression ratio
- Having engine bored to 4.0 and 400 HP N/A....
- N/A to M90
- engine internals
- Refreshing l36, what to check?
- Damaged from an idiot
- lil update on LSS
- N/A Record?
- scan
- This may get moved, But please add some insight
- Custom intake?
- Is anyone looking for ported heads
- Whos going to IDD?
- need help with noise?
- New L36
- Rocker question?
- Fluid leakage around transmission bell housing
- L36 to L67 upgrade.
- m90 upgrade
- shes warm
- IPCM 4Sale
- I have a few questions?
- problem w\ KR in L36 (9*)
- Intake Question
- N/A Set Up
- 3800 series one or two?
- weight reduction
- is intense going to do this?
- Tuned Length Long Tube Headers
- SES Light comes on while pedal to the floor
- Stock valve clearances
- Tim Beek's GT
- FS: 2001 Redfire GT
- new member
- breaking 14s
- Highest N/A Hp question...
- I did it its alive!! it alive!!
- L26 Top end swap???
- CAI cheaper than the K&N FIPK
- NA V6 - where do I start?
- Idling funny- any suggestions?
- plugs bosch or autolite?
- N/A GT stuff for sale
- dimming light, idle drop and loss of engine HP
- Running lean w/L26 UIM
- Anyone else experience this??
- Vacuum Gauge for the NA
- Excessive Knock retard???
- 04 Grand Prix Upgrades?
- Ideas for the LN3 (VIN C)
- Series II L36 vs Series III
- Help,Intense & other L36 gods
- Ok L67 v. L36 performance potential
- Wesxprs
- eaton m90 on an l36 camaro?
- NA 3800 (non stroked) Dyno falls
- L67 Headers on a LN3
- What color are cam bearings suppose to be?
- Hey, I really need some help
- L67 MAF on L36 engine
- Basic L36 mods
- Exhaust
- Intake Manfiold
- 3800 in Toronado Fixed
- Nitrous
- A ZZP GT3 Cam and ZZP Stage II heads?
- Valvetrain question and cam question
- 3800 Shudder
- Is there any boost at all in the L36?
- Anything left to do???
- ideas wanted for aussie 3.8ltr buick v6
- Got rid of MOST of my KR!!!
- Stroker Kit - L36 (Aussie Ecotec)
- Air flow sensor mesh troubles, but sorted with a dyno run and pics
- Series 1 3800 Performance
- Stock Quarter-Mile Times
- Intense shift kit
- Should i get an HVII
- what 60' would be good for an L36
- Plugs and Wires????
- Wes' 220 WHP Dyno Pull
- 2002 V6 Firebird????
- can a GT break 15.0 w/out touching valvetrain?
- is my e-mail getting through
- INTENSE and the L36
- Gen III 1.9 on a L36
- Buck's Dyno Fund
- Help!?!?!?!?!
- 3800 S10 New Best!
- INtense Stage I Cam
- GT will not stay running...
- Went to the Dyno yesterday
- L36/L27 Performance Potential II
- burning oil
- Part Throttle knock?
- L36 Performance Potential
- 3800 II N/A Mods (??NEED RECCOMENDATIONS??)
- mid 14's
- Whats the fastest times with rockers?
- Engine Has a Miss
- who has the quickest NA 3800?
- Just trying to get a general idea
- L27 Mods
- Basic Mods... help needed
- NA bonneville SE
- How do I get 240 hp/280 lb ft from NA L36